redistribute isis
Redistribute IS-IS routes into BGP.
E-Series
Syntax
redistribute isis [level-1 | level-1-2 | level-2] [metric
metric-value | metric-type {external | internal}] [route-map
map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
level-1 | level-1-2
| level-2]
metric
metric-type
route-map
name
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0
Version 7.4.1.0
498
(OPTIONAL) Enter the type (level) of routes to redistribute.
(OPTIONAL) Assign metric to an interface for use with IPv6
information.
(OPTIONAL) The external link type associated with the default route
advertised into a routing domain. You must specify one of the
following:
•
external
•
internal (default)
map-
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
•
match ipv6 address
•
match ipv6 next-hop
•
match ipv6 route-source
•
set ipv6 next-hop
If you do not configure the route map, the default is deny (to drop all
routes).
Introduced on the E-Series ExaScale.
Introduced