Dell Force10 Z9000 Reference Manual page 704

Example
FTOS(conf)#interface range gi 2/1 - 11, gi 2/1 - 23
(Overlapping FTOS(conf-if-range-gi-2/1-23#
Ports)
Usage
Only VLAN and port-channel interfaces created using the interface vlan and
Information
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show running-
config command can not be used with the bulk configuration feature of the interface
range command. You cannot create virtual interfaces (VLAN, Port-channel) using the
interface range command.
Example (Single
This example shows a single range bulk configuration.
Range)
FTOS(config)# interface range gigabitethernet 5/1 - 23
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
Example (Multiple
This example shows how to use commas to add different interface types to the range enabling
Range)
all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces
1/1 and 1/2.
FTOS(config-if)# interface range gigabitethernet5/1-23,
tengigabitethernet1/1-2
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
Example (Multiple
This example shows how to use commas to add SONET, VLAN, and port-channel interfaces to
Range)
the range.
FTOS(config-if)# interface range gigabitethernet5/1-23,
tengigabitethernet1/1–2,
Vlan 2–100, Port 1–25
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
Related
interface port-channel
Commands
interface vlan
show config (from INTERFACE RANGE mode)
show range
interface range macro (define)
704
NOTE: If a range has VLAN, physical, port-channel, and SONET interfaces, only commands
related to physical interfaces can be bulk configured. To configure commands specific to
VLAN, port-channel, or SONET, only those respective interfaces should be configured in a
particular range.
– configures a port channel group.
– configures a VLAN interface.
– shows the bulk configuration ranges.
– defines a macro for an interface-range.
– shows the bulk configuration interfaces.