Set Origin - Dell Force10 Z9000 Reference Manual

Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
If you configure the set next-hop command, its configuration takes precedence over the
Information
neighbor next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface's IP address (either
Loopback or physical), the software declares the route unreachable.
Related
match ip next-hop
Commands
neighbor next-hop-self

set origin

Configure a filter to manipulate the BGP ORIGIN attribute.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the no set origin command.
Parameters
egp
igp
incomplete
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
300
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– redistributes routes that match the next-hop IP address.
– configures the routers as the next hop for a BGP neighbor.
Enter the keyword egp to set routes originating from outside the local
AS.
Enter the keyword igp to set routes originating within the same AS.
Enter the keyword incomplete to set routes with incomplete
routing information.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.