Interface Vlan - Dell Force10 Z9000 Reference Manual

interface range macro (define)

interface vlan

Configure a VLAN. You can configure up to 4096 VLANs.
Z-Series, S4810, and MXL Switch
Syntax interface vlan vlan-id [of-instance{of-id}]
Parameters
vlan-id
of-instance{
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command History
Version 9.1.(0.0)
Version 8.3.11.1
Usage
For more information about VLANs and the commands to configure them, refer to the
Information
LAN (VLAN) Commands
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. For more information, refer to the
chapter.
The following features are not supported on VLANs associated with an OpenFlow instance:
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot be enabled
simultaneously.
Example (Single
FTOS(conf)#int vlan 3
Range) FTOS(conf-if-vl-3)#
Related
interface
Commands
interface loopback
interface null
Enter a number as the VLAN Identifier. The range is 1 to 4096.
of-id }
Enter the keyword of-instance followed by the OpenFlow instance ID
to add the VLAN to the specified OpenFlow instance. Range is 1 to 8.
NOTE: You must associate the OpenFlow instance with the VLAN
when the VLAN is created. An existing VLAN cannot be
associated with an OpenFlow instance.
Introduced on the S4810; added support for OpenFlow.
Introduced on the Z9000.
section of the
• IPv4
• IPv6
• MTU
– configures a physical interface.
– configures a loopback interface.
– configures a null interface.
– defines a macro for an interface range (bulk configuration).
Layer 2 chapter.
Virtual
Access Control Lists (ACL)
707