Show Interfaces Rate - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

Version 6.5.1.0

Enter this command to honor all incoming 802.1p markings on incoming switched traffic on the

interface. By default, this facility is not enabled (that is, the 802.1p markings on incoming traffic

are not honored).

You can apply this command on both physical interfaces and port channels. When you set the

service-class dynamic for a port channel, the physical interfaces assigned to the port channel

are automatically configured; you cannot assign the service-class dynamic command

to individual interfaces in a port channel.

On the C-Series and S-Series, all traffic is by default mapped to the same queue, Queue 0. If

you honor dot1p on ingress, you can create service classes based the queueing strategy using

the service-class dynamic dot1p command from INTERFACE mode. You may apply

this queuing strategy to all interfaces by entering this command from CONFIGURATION mode.

show interfaces rate

Display information of either rate limiting or rate policing on the interface.

show interfaces [interface] rate [limit | police]

Expanded the command to permit configuration on port channels.

Introduced on the E-Series.

All dot1p traffic is mapped to Queue 0 unless you enble the service-class

dynamic dot1p command on an interface or globally.

Layer 2 or Layer 3 service policies supercede dot1p service classes.

(OPTIONAL) Enter the following keywords and slot/port or number

information:

(OPTIONAL) Enter the keyword limit to view the outgoing traffic

(OPTIONAL) Enter the keyword police to view the incoming traffic

For a 100/1000 Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a SONET interface, enter the keyword sonet followed by

the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.