Interface Null - Dell Force10 Z9000 Reference Manual

Parameters
slot/port
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.11.1
Version 8.1.1.0
Version 7.5.1.0
Version 6.4.1.0
Usage
You cannot delete a Management port.
Information
The Management port is enabled by default (no shutdown). Use the ip address
command to assign an IP address to the Management port.
If your system has two RPMs installed, use the show redundancy command to display
which RPM is the Primary RPM.
Example
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
Related
management route
Commands
forwarding router.
duplex (Management)
card.
speed (Management interface)

interface null

Configure a Null interface on the switch.
C-Series, E-Series, S-Series, Z-Series
Syntax interface null number
Parameters
number
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Enter the keyword ManagementEthernet followed by slot
number (0-1) and port number zero (0).
Introduced on the Z9000.
Introduced on the S55, S60, and S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced
– configures a static route that points to the Management interface or a
– clears the forwarding information base (FIB) entries on a specified line
– clears the FIB entries on a specified line card.
Enter zero (0) as the Null interface number.
Introduced on the Z9000.
701