Disable-On-Sfm-Failure; Duplex (Management) - Dell Force10 Z9000 Reference Manual

Related show interfaces description
Commands

disable-on-sfm-failure

Disable select ports on E300 systems when a single switch fabric modules (SFM) is available.
E-Series
Syntax disable-on-sfm-failure
To delete a description, use the no disable-on-sfm-failure command.
Defaults Port is not disabled.
Command Modes INTERFACE
Command History
Version 7.7.1.0
Usage
When an E300 system boots up and a single SFM is active on this configuration, any ports you
Information
configure with this feature are shut down. If an SFM fails (or you remove) in an E300 system
with two SFM, the ports you configure with this feature are shut down. All other ports are
treated normally.
When you install or replace a second SFM, all ports are booted up and treated as normally.
This feature does not take affect until a single SFM is active in the E300 system.

duplex (Management)

Set the mode of the Management interface.
C-Series, E-Series, Z-Series
Syntax duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half
full
Defaults Not configured.
Command Modes INTERFACE
– displays the description field of the interfaces.
Introduced on the E300 systems only.
Enter the keyword half to set the Management interface to transmit
only in one direction.
Enter the keyword full to set the Management interface to transmit
in both directions.
693