Handset Settings Parameters - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
[1]
If you change this parameter, the phone will reboot to make the change take effect.

Handset Settings Parameters

Parameter custom.handset.eco_mode.enable
It enables or disables the eco mode to greatly reduce the transmission power and signal output when
Description
the phone is in the talk mode.
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
Permitted
0-Disabled
Values
1-Enabled
Default
-1
Supported
All handsets except DD phones
Devices
Handset UI OK > Settings > System Settings (Basic Settings) > Eco Mode
Parameter custom.handset.color_scheme
It configures the color scheme of the handset.
Description
Note: It will take effect on all handsets that are registered on the same phone. It works only if the value
of the parameter "static.auto_provision.handset_configured.enable" is set to 1 (Enabled).
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
Permitted
0-Color scheme 1
Values
1-Color scheme 2
Default -1
Supported
W52H
Devices
Handset UI OK > Settings > Display > Color Schemes
Parameter custom.handset.missed_call_notify_light.enable
It enables or disables the message key LED to flash red when the handset misses a call.
Description
Note: It will take effect on all handsets that are registered on the same phone. It works only if "stat-
ic.auto_provision.handset_configured.enable" is set to 1 (Enabled).
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
Permitted
0-Disabled
Values
1-Enabled
Default -1
Supported
W52H
Devices
Handset UI OK > Settings > Display > Notification Light > Missed Call
Parameter custom.handset.voice_mail_notify_light.enable
It enables or disables the message key LED to flash when the handset receives a voice mail.
Description
Note: It will take effect on all handsets that are registered on the same phone. It works only if "stat-
ic.auto_provision.handset_configured.enable" is set to 1 (Enabled).
Permitted
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
155
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg