Return Code For Unanswered Call Configuration; Hide Feature Access Codes; Hide Feature Access Codes Configuration - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones

Return Code for Unanswered Call Configuration

The following table lists the parameters you can use to configure the return code for the unanswered call.
Parameter features.no_answer_code
It configures a return code and reason of SIP response messages when the phone does not answer
Description
an incoming call. A specific reason is displayed on the caller's phone screen.
404-Not Found
480-Temporarily Unavailable (Temporarily not available)
Permitted
486-Busy Here
Values
600-Busy Everywhere
603-Decline
Default 486
Supported
All phones except T48G, T46G, T42G, T41P and T29G
Devices
Web UI Features > General Information > Return Code When No Answer

Hide Feature Access Codes

Hide Feature Access Codes feature enables the IP phone to display the feature name instead of the dialed feature
access code automatically. For example, the dialed call park code will be replaced by the identifier "Call Park"
when you park an active call.
The hide feature access codes feature is applicable to the following features:
Voice Mail
l
Pick up
l
Group Pick up
l
Barge In (not applicable to T30P/T30/T19(P) E2/CP920/CP925/CP935W phones)
l
Retrieve
l
Call Park
l
Call Pull (not applicable to T30P/T30/T19(P) E2/CP920/CP925/CP935W phones)
l
Topic

Hide Feature Access Codes Configuration

Hide Feature Access Codes Configuration
The following table lists the parameters you can use to configure the hide feature access codes.
Parameter features.hide_feature_access_codes.enable
It enables or disables the phone to display the feature name instead of the feature access code when
dialing and talking.
The following feature access codes will be replaced when this feature is enabled:
Voice Mail
l
Description
Pick up
l
Group Pick up
l
Barge In
l
Retrieve
l
Call Park
l
549
<y0000000000xx>.cfg
<y0000000000xx>.cfg