Warnings Display; Warnings Display Configuration; Out Of Service; Out Of Service Configuration - Yealink SIP-T3 Administrator's Manual

Values
Default
Blank
Supported
T57W, T54W, T53C, T48U, T48S, T46U, T46S
Devices
[1]
If you change this parameter, the phone will reboot to make the change take effect.

Warnings Display

When one of the following situations occurs:
The default password is being used
l
Account registration failed
l
Provisioning credentials are wrong
l
Network is unavailable
l
Line on redundancy registration
l
On the T42S/T42U/T41S phones, a warning message appears on the idle screen.
On the other phones, a warning icon appears in the status bar.
Topic

Warnings Display Configuration

Warnings Display Configuration
The following table lists the parameter you can use to configure the warnings display.
Parameter phone_setting.warnings_display.mode
Description It enables or disables the phone to display warnings.
0-Disabled
Permitted
Values
1-Enabled
Default 1
Supported
All phones except T48G, T46G, T42G, T41P and T29G
Devices

Out of Service

When the network of the phone is disconnected and the warning message appears on the screen, the phone will
play an alert tone.
Topic

Out of Service Configuration

Out of Service Configuration
The following table lists the parameter you can use to configure out of service.
Parameter features.out_of_service_alert.enable
It enables or disables the phone to play an alert tone when out of service caused by network abnor-
mality.
Description
Note: You can customize the alert tone by the parameter "voice.tone.congestion".
Permitted 0-Disabled
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Phone Customization
325