Example: Configuring The Satellite Mode Feature - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
Web UI Status > Handset > Satellite Mode > Select Handset
T57W/T54W/T53C:
Menu > DECT Settings > Satellite Mode > Select handset
Phone UI
T53W/T53:
Menu > Settings > DECT Settings > Satellite Mode > Select handset
Parameter features.ms.X.mode
It configures the satellite mode for the phone.
Description
Note: It works only if "features.ms.X.slave_handset_number" is configured correctly.
0-Busy, users cannot switch the active call between the phone and handset. Regardless of the phone
or the handset, the device which is during the call can initiate a new call. If users not in a call try to ini-
Permitted
tiate a call on the phone/handset, the phone/handset will prompt "Path Busy".
Values
1-Take over call, when the handset is during the call, users can retrieve the call after off-hook on the
phone. When the phone is during the call, users can push the call to the handset.
Default 1
Web UI Status > Handset > Satellite Mode > Mode
T57W/T54W/T53C:
Menu > DECT Settings > Satellite Mode > Select mode
Phone UI
T53W/T53:
Menu > Settings > DECT Settings > Satellite Mode > Select mode
[1]
X is the handset ID. X is equal to 1.

Example: Configuring the Satellite Mode Feature

You can configure the satellite mode only when one handset is registered to the phone.
The following table lists the supported phones and handsets:
Phone
T57W
T54W
T53W
T53
T53C
As an example, two W56H handsets along with two T54W phones are in use.
153
[1]
<y0000000000xx>.cfg
Handset
W53H
W56H
W59R