End Call On Hook; End Call On Hook Configuration - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
The incoming line for handset 3 is line 3.
The incoming line for handset 4 is line 4.
The incoming line for handset 5 is line 5.
Web UI Account > Number Assignment > Incoming lines
Parameter handset.X.dial_out_lines
It configures the lines to place outgoing calls for a specific handset.
Description
Multiple line IDs are separated by commas.
1-Line 1
2-Line 2
Permitted
3-Line 3
Values
4-Line 4
5-Line 5
The outgoing line for Corded phone is line 1-line5.
The outgoing line for handset 2 is line 2.
Default
The outgoing line for handset 3 is line 3.
The outgoing line for handset 4 is line 4.
The outgoing line for handset 5 is line 5.
Web UI Account > Number Assignment > Outgoing lines
Parameter handset.X.dial_out_default_line
Description It configures the default line to place outgoing calls for a specific handset.
Permitted
Integer from 1 to 5
Values
Default X
Supported
All handsets except CP930W
Devices
Web UI Account > Number Assignment > Outgoing lines > Default
[1]
X is the handset ID. X=1-5.

End Call on Hook

You can configure whether to end a call when you place the handset into the charging cradle.
Topic

End Call on Hook Configuration

End Call on Hook Configuration
The following table lists the parameter you can use to configure the end call on hook.
Parameter phone_setting.end_call_on_hook.enable
Description It enables or disables to end a call when placing the handset into the charger cradle.
Permitted
0-Never
Values
141
[1]
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg