Default Account - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
Default {L}_{1}
Supported
All phones except T30P, T30, T19(P) E2 and CP920
Devices
[1]
X is the account ID. For T57W/T54W/T48U/T48S/T48G/T46U/T46S/T46G/T29G, X=1-16; for
T53W/T53/T53C/T43U/T42U/T42G/T42S, X=1-12; for T41P/T41S/T27G, X=1-6; for T33P/T33G, X=1-4; for
T40P/T40G/T23P/T23G, X=1-3; for T31P/T31G/T31/T21(P) E2, X=1-2; for CP925/CP935W, X=1.

Default Account

If there are multiple accounts registered on the phone, the phone will use the default account to dial out by default.
The following table lists the parameters you can use to configure the default account.
Parameter static.features.default_account
It configures the default account.
1-Account 1
2-Account 2
3-Account 3
...
16-Account 16
101-PSTN 1
102-PSTN 2
Description
For T57W/T54W/T48U/T48S/T48G/T46U/T46S/T46G/T29G, accounts 1-16, PSTN 1 and PSTN 2.
(PSTN 1 and PSTN 2 are only applicable to T57W/T54W phones)
For T53W/T53/T53C/T43U/T42U/T42S/T42G, accounts 1-12, PSTN 1 and PSTN 2. (PSTN 1 and
PSTN 2 are only applicable to T53W/T53/T53C phones)
For T41P/T41S/T27G, accounts 1-6.
For T33P/T33G, accounts 1-4.
For T40P/T40G/T23P/T23G, accounts 1-3.
For T31P/T31G/T31/T21(P) E2, accounts 1-2.
For CP920/CP925: account 1, PSTN 1 and PSTN 2.
Permitted
Integer from 1 to 16, 101, 102
Values
Default
1
Supported
All phones except T30P/T30/T19(P) E2
Devices
Parameter features.show_default_account
It enables or disables the phone to display the label of the default account in the left of the status bar
on the idle screen.
Description
Note: For T43U/T42G/T42S/T42U/T41P/T41S/T27G phones, the label of the default account is dis-
played in the middle bottom of the idle screen. It works only if "features.station_name.value" is left
blank.
Permitted
0-Disabled
1-Enabled
Values
352
<y0000000000xx>.cfg
<y0000000000xx>.cfg