Phone Reboot; Rebooting The Ip Phone Remotely; Notify Reboot Configuration; Rebooting The Device Via The Phone User Interface - Yealink SIP-T3 Administrator's Manual

1. Open a web browser on your computer.
2. Enter the IP address in the browser's address bar, and then press the Enter key.
For example, "http://192.168.0.10" for IPv4 or "http://[2005:1:1:1:215:65ff:fe64:6e0a]" for IPv6.
3. Enter the user name (admin) and password (admin) in the login page.
4. Click Login to log in.
The device status is displayed on the first page of the web user interface.

Phone Reboot

You can reboot the IP phone remotely or locally.
Topics

Rebooting the IP Phone Remotely

Rebooting the Device via the Phone User Interface

Rebooting the Device via Web User Interface
Rebooting the IP Phone Remotely
You can reboot the phones remotely using a SIP NOTIFY message with "Event: check-sync" header. Whether the IP
phone reboots or not depends on "sip.notify_reboot_enable". If the value is set to 1, or the value is set to 0 and the
header of the SIP NOTIFY message contains an additional string "reboot=true", the phone will reboot immediately.
The NOTIFY message is formed as shown:
NOTIFY sip:<user>@<dsthost> SIP/2.0
To: sip:<user>@<dsthost>
From: sip:sipsak@<srchost>
CSeq: 10 NOTIFY
Call-ID: 1234@<srchost>
Event: check-sync;reboot=true
Topic

Notify Reboot Configuration

Notify Reboot Configuration
The following table lists the parameter you can use to configure notify reboot.
Parameter sip.notify_reboot_enable
It configures the IP phone behavior when receiving a SIP NOTIFY message which contains the
Description
header "Event: check-sync".
0-The phone will reboot only if the SIP NOTIFY message contains an additional string "reboot=true".
Permitted
1-The phone will reboot.
Values
2-The phone will ignore the SIP NOTIFY message.
Default 1
Rebooting the Device via the Phone User Interface
You can reboot your device via the phone user interface.
Procedure
Troubleshooting Methods
<y0000000000xx>.cfg
617