Vq-Rtcpxr Display - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
Permitted
Integer from 15 to 40
Values
Default
Blank
Web UI Settings > Voice Monitoring > Critical Threshold for Moslq
Parameter phone_setting.vq_rtcpxr_delay_threshold_warning
It configures the threshold value of one-way delay (in milliseconds) that causes the phone to send a
warning alert quality report to the central report collector.
For example, if it is set to 500, when the value of one way delay computed by the phone is greater
than or equal to 500, the phone will send a warning alert quality report to the central report collector;
Description
when the value of one way delay computed by the phone is less than 500, the phone will not send a
warning alert quality report to the central report collector.
If it is set to blank, warning alerts are not generated due to one-way delay. The one-way delay
includes both network delay and end system delay.
Permitted
10 to 2000
Values
Default Blank
Web UI Settings > Voice Monitoring > Warning Threshold for Delay
Parameter phone_setting.vq_rtcpxr_delay_threshold_critical
It configures the threshold value of one-way delay (in milliseconds) that causes the phone to send a
critical alert quality report to the central report collector.
For example, if it is set to 500, when the value of one-way delay computed by the phone is greater
than or equal to 500, the phone will send a critical alert quality report to the central report collector;
Description
when the value of one way delay computed by the phone is less than 500, the phone will not send a
critical alert quality report to the central report collector.
If it is set to blank, critical alerts are not generated due to one-way delay. The one-way delay includes
both network delay and end system delay.
Permitted
10 to 2000
Values
Default Blank
Web UI
Settings > Voice Monitoring > Critical Threshold for Delay
Parameter phone_setting.vq_rtcpxr.min_callduration
It configures the minimum call duration time (in seconds) that causes the phone to send a session
quality report to the central report collector.
Description If it is set to 0, the phone will send a session quality report to the central report collector at the end of
each call.
Note: It works only if "phone_setting.vq_rtcpxr.session_report.enable" is set to 1 (Enabled).
Permitted
Integer from 0 to 60
Values
Default 0

VQ-RTCPXR Display

You can check the voice quality data of the last call via the web user interface or phone user interface. You can also
specify the options of the RTP status to be displayed on the phone user interface. Options of the RTP status dis-
played on the web user interface cannot be specified.
213
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg