Music On Hold (Moh) Configuration - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
seconds.
Note: It works only if the Music on Hold feature is disabled and "features.play_held_tone.enable" is
set to 1 (Enabled).
Permitted
Integer from 3 to 3600
Values
Default 60
Web UI
Features > General Information > Held Tone Interval(second)
Parameter phone_setting.hold_or_swap.mode
It configures the display rule of the Hold/Swap soft key when there are two calls on the phone.
Description
Note: You can also configure the softkey layout feature to display the Hold or Swap soft key.
0-Only display the Swap soft key.
Permitted
1-Only display the Hold soft key.
Values
2-Display the Hold and Swap soft keys.
Default 0
Related
phone_setting.custom_softkey_enable
Parameters
[1]
X is the account ID. For T57W/T54W/T48U/T48S/T48G/T46U/T46S/T46G/T29G, X=1-16; for
T53W/T53/T53C/T43U/T42G/T42U/T42S, X=1-12; for T41P/T41S/T27G, X=1-6; for T33P/T33G, X=1-4; for
T40P/T40G/T23P/T23G, X=1-3; for T31P/T31G/T31/T21(P) E2, X=1-2; for T30P/T30/T19(P)
E2/CP920/CP925/CP935W, X=1.

Music on Hold (MoH) Configuration

When a call is placed on hold, the phone will send an INVITE message to the specified MoH server account accord-
ing to the SIP URI. The MoH server account automatically responds to the INVITE message and immediately plays
audio from some source located anywhere (LAN, Internet) to the held party. For more information, refer to draft RFC
draft-worley-service-example.
The following table lists the parameters you can use to configure music on hold.
Parameter account.X.music_server_uri
It configures the address of the Music On Hold server.
Examples for valid values: <10.1.3.165> , 10.1.3.165, sip:moh@sip.com, <sip:moh@sip.com> ,
Description
<yealink.com > or yealink.com.
Note: The DNS query in this parameter only supports A query.
Permitted
SIP URI within 256 characters
Values
Default
Blank
Web UI Account > Advanced > Music Server URI
Parameter account.X.music_on_hold_type
Description It configures the way to process Music On Hold when placing an active call on hold.
0-Calling the Music On Hold server before holding the call
Permitted
Values
1-Calling the Music On Hold server after holding the call
Default 0
440
<y0000000000xx>.cfg
[1]
<MAC>.cfg
[1]
<MAC>.cfg