Configuration Manager; Splash Screen Loading - Garmin G1000 Nxi System Maintenance Manual

8. If applicable, rotate the large FMS knob to select the "DOMAIN IDENTIFIER" field and
enter the number. Otherwise, leave blank.
9. Rotate the large FMS knob to select the "VFR CODE" field and enter the desired code
that will become active when the VFR key on a PFD is pressed.
10. Press the Set GTX2 softkey and acknowledge the PFD1 prompt by pressing the ENT
key.
11. Press the Set GTS softkey (if present) and acknowledge the PFD1 prompt by pressing
the ENT key.
12. Deactivate the cursor.
13. Rotate large FMS knob to select "GTX 3X5" configuration page group.
14. Rotate the small FMS knob to select "Transponder Airframe Configuration" page.
15. Verify the GTX1 box at the top of the page is green and the tail number, ICAO address,
and VFR code that were entered previously are correct.

Configuration Manager

1. On PFD1, rotate the large FMS knob to select "SYSTEM" configuration page group.
2. Rotate the small FMS knob to select Configuration Manager page.
3. Press the softkey labelled CNFM CFG on PFD1.
4. Press the ENT key on PFD1 to select OK when prompted to confirm configuration as
expected configuration.
5. Open MFD, PFD 1 (PRI), PFD 1 (SEC), and PFD 2 circuit breakers.

Splash Screen Loading

When all software and configuration has been loaded, the splash screens must be loaded to all
display units (PFD1, PFD2 and MFD).
1. Insert the software loader card in the upper slot of PFD2.
2. Close PFD2 circuit breaker.
3. When prompted to update system files, press the NO softkey.
4. When prompted to update splash screen files, press the YES softkey.
5. When the SYSTEM STATUS page appears, open the PFD2 circuit breaker.
6. Remove the loader card from PFD2 and insert it into the upper slot of the MFD.
7. Close MFD circuit breaker.
8. When prompted to update system files, press the NO softkey.
9. When prompted to update splash screen files, press the YES softkey.
10. When the SYSTEM STATUS configuration page appears, open MFD circuit breaker.
11. Remove the loader card from the MFD and insert it into the upper slot of PFD1.
12. Close PFD 1 (PRI) circuit breaker.
13. When prompted to update system files, press the NO softkey.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Page 86
Revision 1