Garmin G1000 Nxi System Maintenance Manual page 295

11) Non Garmin Options (For GEA 2 replacement and aircraft equipped
with a FDR)
1. Scroll the curser to the Group window and select "11) Non Garmin Options".
2. Press the ENT key.
3. In the ITEM window highlight the aircraft's engine and prop combination and press the
ENT key on PFD1.
4. Press the CLR ALL softkey.
5. Scroll the curser to GEA 2 configuration box, and press the ENT key to check the box.
6. Press "Load" softkey.
7. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
8. Acknowledge the prompt by pushing the ENT key.
Configuration Manager Update
1. With the system still in configuration mode, scroll to the Configuration Manager page on
PFD 1.
2. Press the CNFM CFG softkey.
3. Select ok when prompted to "Confirm configuration as expected configuration"
4. Power cycle the system. Verify there are no red-Xs or system alerts.
5. If red-Xs or system alerts are present, troubleshoot as necessary using Section
6. If there are no red-Xs or system alerts, test the GEA per Section 7.4.3.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
5.
Page 282
Revision 1