Aircraft Registration Number Entry - Garmin G1000 Nxi System Maintenance Manual

POTS Handset Configuration
Follow this procedure to enable a POTS handset if installed. Note that the GDL 59 Wi-Fi data
link option must be loaded per Section 3.8.8 prior to loading the POTS handset configuration.
1. Power on PFD1 in configuration mode.
2. On the PFD1, select GDL page group using the large FMS knob.
3. Using the small FMS knob select the GDL 59 Configuration page.
4. Activate the cursor. Use the large FMS knob to select POTS CONNECTED in the PHONE
SETTINGS field.
5. Use the small FMS knob to select YES and press the ENT key.
6. After GDL 59 is configured, press the ENT key.

Aircraft Registration Number Entry

Steps to complete the aircraft registration entry are dependent on
transponder equipment installed. Choose the appropriate procedure from
Section 3.10.1 or 3.10.2 to complete the aircraft registration entry.
Equipped with Dual GTX 33s or GTX 3000s
1. Power on PFD1 in configuration mode. Select the AIRCRAFT CONFIGURATION page
on PFD1.
2. Activate the cursor to select the "AIRCRAFT REGISTRATION" field and enter the
aircraft's tail number.
3. For non-US "N" number aircraft registrations, rotate the large FMS knob to select the
"ICAO ADDRESS" and enter the aircraft's 24 bit ICAO address. US "N" number aircraft
registrations are automatically decoded and entered in this field, do not change the
number.
4. If applicable, rotate the large FMS knob to select the "ICAO REGION" field and select
the ICAO region. Otherwise, leave at "NONE".
5. If applicable, rotate the large FMS knob to select the "DOMAIN IDENTIFIER" field and
enter the number. Otherwise, leave blank.
6. Rotate the large FMS knob to select the "VFR CODE" field and enter the desired code
that will become active when the VFR key on a PFD is pressed.
7. For GTX 33 units only, press the Set GTX1 softkey and acknowledge the PFD1 prompt
by pressing the ENT key. Repeat for the Set GTX2 softkey.
8. For GTX 3000 units only, press the SET GTX softkey and acknowledge the PFD1
prompt by pressing the ENT key.
9. Press the Set GTS softkey (if present) and acknowledge the PFD1 prompt by pressing
the ENT key.
10. After completing transponder configuration, deactivate the cursor.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 84
Revision 1