Garmin G1000 Nxi System Maintenance Manual page 94

•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the "Upload Complete" box.
Open PFD1 circuit breaker and remove SAR enablement card.
GTS TCAS I Enablement
Follow this procedure to enable Garmin GTS TCAS I feature. If TCAS II is desired instead, go
to Section 3.9.12.
Insert the TCAS I Enablement card in the top slot of PFD1, power on PFD1 in
configuration mode.
On PFD1, select the "System Upload" page using the small FMS knob.
Push in the FMS knob to activate the curser in the Group field. Rotate the small FMS
knob to highlight "GTS Processor Enablement" and press the ENT key to select it.
In the ITEM window, rotate the small FMS knob to highlight "GTS Processor TAS to
TCAS I Enablement" and press the ENT key to select it.
Press the Load softkey.
Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration column for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the "Upload Complete" box.
Open PFD1 circuit breaker and remove the Enhanced TCAS I enablement card.
GTS TCAS II Enablement
Follow this procedure to enable the Garmin GTS TCAS II feature.
Insert the TCAS II Enablement card in the top slot of PFD1, power on PFD1 in
configuration mode.
On PFD1, select the "System Upload" page using the small FMS knob.
Push in the FMS knob to activate the curser in the Group field. Rotate the small FMS
knob to highlight "GTS Processor Enablement" and press the ENT key to select it.
In the ITEM window, rotate the small FMS knob to highlight "GTS Processor TAS to
TCAS II Enablement" and press the ENT key to select it.
Press the Load softkey.
Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration column for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the "Upload Complete" box.
Open PFD1 circuit breaker and remove the Enhanced TCAS II enablement card.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Page 81
Revision 1