Garmin G1000 Nxi System Maintenance Manual page 273

11. Deactivate the curser.
12. Scroll to the Configuration Manager page.
13. Press the CNFM CFG softkey.
14. Select ok when prompted to "Confirm configuration as expected configuration"
15. Power cycle the system. Verify there are no red-Xs or system alerts.
16. If red-Xs or system alerts are present, troubleshoot as necessary using Section 5 or re-
load the system using the legacy method in Section 3.8.
17. If there are no red-Xs or system alerts, continue to Section 7.1.7.
Legacy Replacement Procedure PFD2 (Alternate Method)
A full system configuration re-load is required when a new, repaired, or exchanged display is
installed using this method. This includes all options and feature enablements.
1. To complete this procedure, perform Section 3.8.
LRU Replacement Procedure MFD
Anytime the MFD is replaced, all databases will have to be reloaded.
1. Open the MFD, PFD 1 (PRI), PFD 1 (SEC), and PFD 2 circuit breakers.
2. Remove SD cards from top and bottom slots of PFD2, MFD, and PFD1 if present.
3. Apply power to the G1000 system by connecting external power to the aircraft to
energize the aircraft and avionics electrical busses.
4. Turn on Avionics electrical busses.
5. Power on PFD2, MFD, and PFD1 in configuration mode.
6. Using the PFD1, scroll to the LRU replacement page.
7. Activate the curser and select MFD in the LRU dropdown box.
8. Press the CHK All softkey.
9. Press the Load softkey.
10. Press ENT to acknowledge the process was complete.
11. Deactivate the curser.
12. Scroll to the Configuration Manager page.
13. Press the CNFM CFG softkey.
14. Select ok when prompted to "Confirm configuration as expected configuration"
15. Power cycle the system. Verify there are no red-Xs or system alerts.
16. If red-Xs or system alerts are present, troubleshoot as necessary using Section 5 or re-
load the system using the legacy method in Section 3.8.
17. Install databases Section 3.14 to re-load databases.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 260
Revision 1