Garmin G1000 Nxi System Maintenance Manual page 381

3. Use the large FMS knob to scroll the cursor to GSR1 (if GSR 56 is installed). Record the
GSR 56 serial number shown in the LRU INFO field.
For previously activated systems, if the GSR 56 satellite receiver unit is replaced, the new unit
serial number must be registered with Garmin Connext. Contact Garmin Product Support and
follow the activation procedure as described previously in this section.
For previously activated systems, if the GDL 59 Wi-Fi datalink unit is replaced, the system must
be registered again. This can be accomplished by entering the same passcode received during
the initial activation process as described in the following steps:
1. Connect to an available network (reference Section 8.16 for details.)
2. Using the large FMS knob, select the Aux page group on the MFD. Using the small
FMS knob, select the Map – Weather Data Link page.
3. Press the MENU key on the GCU to display the PAGE MENU window.
4. Select "Register With Connext".
5. With the "Connext Registration" window open, enter the access code (provided by
Garmin Product Support during the initial activation of the system) in the Access Code
field, using the keypad on the GCU, and press the ENT key on the GCU.
The replacement GDL 59 unit must be registered again, even if the MFD
already shows Registered in the Status window.
6. With the Register field highlighted, press the ENT key on the GCU.
7. Verify that the Status field indicates Registered and that the data displayed in the Current
Registration field matches the aircraft information.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
SYSTEM ID Number Location
Page 368
Revision 1