Garmin G1000 Nxi System Maintenance Manual page 333

Legacy Replacement Procedure GSA80 Servos (Alternate Method)
1. Insert the software loader card in the top slot of PFD1.
2. Power on PFD2, MFD, and PFD1 in configuration mode.
3. Select NO when "Do you want to update system files" is displayed on the screen of
PFD1.
4. Select the "SYSTEM UPLOAD" page using the small FMS knob on PFD1.
5. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate
the large FMS knob to highlight "05) Autopilot" and press ENT key on PFD1.
6. Rotate the small FMS knob to display the drop down menu. Rotate the large FMS knob
highlight the installed autopilot configuration. Press ENT key on PFD1.
7. Press the CLR ALL key.
8. Scroll to highlight the installed servo.
9. Highlight the software box and press the ENT key to check the box.
10. Scroll to highlight the installed servo cert line.
11. Highlight the software box and press the ENT key to check the box.
12. Press the Load softkey.
13. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
14. Press ENT key on PFD1 to acknowledge upload complete.
15. Deactivate cursor.
16. Scroll to the Configuration Manager page.
17. Press the CNFM CFG softkey.
18. Select ok when prompted to "Confirm configuration as expected configuration"
19. Power cycle the system. Verify there are no red-Xs or system alerts.
20. If red-Xs or system alerts are present, troubleshoot as necessary using Section 5.
21. If there are no red-Xs or system alerts, continue to return to service checks in Section 9.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Page 320
Revision 1