Garmin G1000 Nxi System Maintenance Manual page 376

22. Once AFCS PFT is complete and GPS has acquired satellites, verify on PFD1 and PFD2
the ESP Roll Indices are not displayed at 45° on the roll indicator on the Attitude Display.
23. On the GCU, rotate the inner FMS knob to activate the Aux – System Setup page.
24. On the MFD Aux – System Setup page press the Setup 2 softkey.
25. Verify that on the Aux – System Setup 2 page there is a window for Stability & Protection
and the status is "ENABLED".
26. Verify on PFD 1 and PFD 2 that there are no "ESP FAIL" or "ESP OFF" alert messages.
27. On the GMC 710, couple the Flight Director to the right side by pressing the XFR button.
The arrow that is illuminated indicates which side is coupled. No flight director modes
should be active at this time.
On power up the coupled side will default to the left side. Each time power
is reapplied couple back to the right side and continue test steps.
28. Repeat step 1 thru 27 while coupled to right side.
29. Remove power to the aircraft and avionics systems by placing the aircraft AVIONICS
MASTER PWR, EXT PWR, and BATT switches to OFF.
30. Wait ~ 1 minute before re-applying power for further testing as required.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 363
Revision 1