Garmin G1000 Nxi System Maintenance Manual page 96

6. Press the CHK ALL softkey.
7. In the product window, move the cursor to highlight "CARD COPY". Press the ENT key
to uncheck the configuration check box.
8. Press the Load softkey.
9. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration column for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
10. Press the ENT key to acknowledge the "Upload Complete" box.
11. Open PFD1 circuit breaker and remove the software loader card.
TAWS-A Voice Callout Enablement
This file is designed to allow the installer to re-enable the 1, 2, 3, and 4 hundred foot callouts if
the no voice callout option was loaded previously. This file is not required to enable the voice
callouts if the no voice callout option was not loaded previously. The voice callouts are enabled
by default in the baseline configuration.
1. Insert the software loader card in the top slot of PFD1, power on PFD1 in configuration
mode.
2. Press the NO softkey (number 11 softkey) to acknowledge the following prompt.
3. On PFD1, select the "System Upload" page using the small FMS knob.
4. Push in the FMS knob to activate the curser in the Group field. Rotate the small FMS
knob to highlight "10) Garmin Feature Support" and press the ENT key to select it.
5. In the ITEM window, rotate the small FMS knob to highlight "Activate Garmin
FliteCharts Only (Disables Dual Charts and ChartView" and press the ENT key to
select it.
6. Press the CHK ALL softkey.
7. In the product window, move the cursor to highlight "CARD COPY". Press the ENT key
to uncheck the configuration check box.
8. Press the Load softkey.
9. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration column for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
10. Press the ENT key to acknowledge the "Upload Complete" box.
11. Open PFD1 circuit breaker and remove the software loader card.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Page 83
Revision 1