Figure 7-2, Aux - Gps Status Page (Mfd) - Garmin G1000 Nxi System Maintenance Manual

6. In the ITEM window highlight Enhanced AFCS Press ENT key on PFD1.
7. Press the CLR ALL softkey.
8. Scroll the curser to GIA1 or GIA 2 configuration box, whichever was replaced, and press
the ENT key to check the box.
9. Press "Load" softkey.
10. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
11. Acknowledge the prompt by pushing the ENT key.
Configuration Manager Update
1. With the system still in configuration mode, scroll to the Configuration Manager page on
PFD 1.
2. Press the CNFM CFG softkey.
3. Select ok when prompted to "Confirm configuration as expected configuration".
4. Power cycle the system. Verify there are no red-Xs or system alerts.
5. If red-Xs or system alerts are present, troubleshoot as necessary using Section
6. If there are no red-Xs or system alerts, continue to Section 7.3.3.
GIA 63W Test
GPS Signal Acquisition
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Figure 7-2, Aux – GPS Status Page (MFD)
5.
Page 276
Revision 1