11) Non Garmin Options (For GMA 1 or GMA 2 replacement and aircraft
equipped with a ADF only)
1. Scroll the curser to the Group window and select 11) Non-Garmin options.
2. Press the ENT key.
3. In the ITEM window highlight King Air – ADF Option and press the ENT key on PFD1.
4. Press the CLR ALL softkey.
5. Scroll the curser to GMA 1 or GMA 2 configuration box, whichever was replaced, and
press the ENT key to check the box.
6. Press "Load" softkey.
7. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
8. Acknowledge the prompt by pushing the ENT key.
11) Non Garmin Options (For GMA 1 or GMA 2 replacement and aircraft
equipped with a DME only)
1. Scroll the curser to the ITEM window highlight King Air – DME Option and press the ENT
key on PFD1.
2. Press the CLR ALL softkey.
3. Scroll the curser to GMA 1 or GMA 2 configuration box, whichever was replaced, and
press the ENT key to check the box.
4. Press "Load" softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
6. Acknowledge the prompt by pushing the ENT key.
Configuration Manager Update
1. With the system still in configuration mode, scroll to the Configuration Manager page on
PFD 1.
2. Press the CNFM CFG softkey.
3. Select ok when prompted to "Confirm configuration as expected configuration"
4. Power cycle the system. Verify there are no red-Xs or system alerts.
5. If red-Xs or system alerts are present, troubleshoot as necessary using Section
6. If there are no red-Xs or system alerts, continue to Section 7.2.3.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
5.
Page 264
Revision 1