Garmin G1000 Nxi System Maintenance Manual page 87

1. Rotate the large FMS knob until the Group field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select "09) Garmin
Traffic Systems" and press the ENT key to select it.
2. In the ITEM window, rotate the small FMS knob to highlight the item that was checked
on the Configuration checklist in Section 3.6 in the 09) Garmin Traffic Systems checklist
group and press the ENT key to select it.
3. Press the CHK All softkey.
4. In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
5. Press the Load softkey.
6. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
7. Press the ENT key to acknowledge the "Upload Complete" box.
10) Garmin Feature Support Configuration Load
This section applies only to installations with the TAWS-A option. The procedures outlined in
this section must be followed to load the necessary configuration files required to enable TAWS-
A gear and flap messages. A TAWS-A enablement card is also required for this option.
TAWS-A Voice No Callout applies only to installations with the TAWS-A
option. If TAWS-A voice callouts (400, 300, 200, and 100 feet) are not
desired, follow the procedures outlined in this section to load the
necessary configuration files to disable TAWS-A voice callouts.
1. Rotate the large FMS knob until the Group field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select "10) Garmin
Feature Support" and press the ENT key to select it.
2. In the ITEM window, rotate the small FMS knob to highlight the first item that was
checked on the Configuration checklist in Section 3.6 in the 10) Garmin Feature Support
checklist group and press the ENT key to select it.
3. In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
4. Press the LOAD softkey.
5. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
6. Press the ENT key to acknowledge the "Upload Complete" box.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 74
Revision 1