Garmin G1000 Nxi System Maintenance Manual page 82

01) Baseline Software and Configuration Load
If the aircraft being modified has incorporated any modifications beyond
factory configuration that effect engine or airspeed limitations, your
configuration may not be supported at this time. It is the responsibility of
the installer to ensure compatibility with existing modifications.
Do not allow power to be removed from the system when loading software.
Remove power only when instructed by the following procedures.
As a general rule, all displays should be in the same mode (configuration or
normal) unless instructed otherwise.
Follow the order of software and configuration loading, do not skip or
rearrange steps.
Do not operate or turn off MFD and/or PFD2 while loading software and
configuration files unless specifically instructed to do so. A failed or
cancelled load may result.
If an incorrect configuration file is loaded at any time during this procedure,
STOP and start the configuration load over at Step 2 in this Section.
1. Ensure all avionics circuit breakers are closed and the G1000 system is fully powered.
2. On PFD1, go to the SYSTEM UPLOAD page using the small FMS knob.
3. Push in the PFD1 FMS knob to activate the cursor in the Group field. Rotate the small
FMS knob to activate the drop-down menu. Rotate the small FMS knob to highlight "01)
Baseline" in the drop-down menu and press the ENT key to select it.
4. Once "01) Baseline" is selected, the cursor moves to the ITEM window. Rotate the
small FMS knob to activate the drop-down menu. Highlight "King Air 200-300 Series
Baseline Load" and press the ENT key to select it. The PRODUCT field will then
populate.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
IMPORTANT
Page 69
Revision 1