Garmin G1000 Nxi System Maintenance Manual page 84

Not all propellers are available for selection with each airframe and
engine configuration. Only those props that are approved for installation
on a particular airframe/engine are available in the drop down selection
window.
6. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" or White "N/A" in all Configuration and Software columns.
•
"Upload Complete.............COMPLETE" in the summary box.
7. Press the ENT key to acknowledge the "Upload Complete" box.
04) AHRS – Air Data Software and Configuration Load
Follow this procedure to configure the AHRS, Air Data, or ADAHRS units in the aircraft.
1. Move the cursor to the Group window and rotate FMS inner knob to display drop down
menu. Highlight "04) AHRS – Air Data" and press the ENT key to select it.
2. In the ITEM window, rotate the small FMS knob to highlight the first item that was
checked on the Configuration checklist in Section 3.6 in the 04) AHRS-Air Data checklist
group and press the ENT key to select it.
3. Press the CHK All softkey.
4. In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
5. Press the Load softkey.
6. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
7. Press the ENT key to acknowledge the "Upload Complete" box.
8. If two selections were made for this section on the Configuration checklist (one AHRS
and one ADC), repeat steps 2-7 to load the second file.
05) Autopilot Software and Configuration Load
Follow this procedure to configure the autopilot type and GSM servo mounts installed.
1. Move the cursor to the Group window and rotate FMS inner knob to display drop down
menu. Highlight "05) Autopilot" and press the ENT key to select it.
2. In the ITEM window, rotate the small FMS knob to highlight the first item that was
checked on the Configuration checklist in Section 3.6 in the 05) Autopilot checklist group
and press the ENT key to select it.
3. Press the CHK All softkey.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 71
Revision 1