Garmin G1000 Nxi System Maintenance Manual page 86

4. In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
5. Press the Load softkey.
6. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
7. Press the ENT key to acknowledge the "Upload Complete" box.
8. If multiple selections were made for this section on the Configuration checklist, repeat
steps 2-7 to load each additional item on the Configuration checklist.
08) Radar Software and Configuration Load
Follow this procedure to configure GWX 70 and GRA 5500 if installed.
1. Rotate the large FMS knob until the Group field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select "08) Radar" and
press the ENT key to select it.
2. In the ITEM window, rotate the small FMS knob to highlight the first item that was
checked on the Configuration checklist in Section 3.6 in the 08) Radar checklist group
and press the ENT key to select it.
3. Press the CHK All softkey.
4. In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
5. Press the Load softkey.
6. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
7. Press the ENT key to acknowledge the "Upload Complete" box.
8. If two selections were made for this section on the Configuration checklist, repeat steps
2-7 to load the second item.
09) Garmin Traffic Systems Software and Configuration Load
Follow this procedure to configure Garmin Traffic Systems if installed.
The G1000 can only be configured for TIS or TAS/TCAS but not both.
Performing this procedure will automatically disable the TIS function.
Configuration of the GTS Processor will require entering the aircraft
registration number into the unit using Section 3.10 "Aircraft Registration
Number Entry".
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 73
Revision 1