Garmin G1000 Nxi System Maintenance Manual page 98

Equipped with Dual GTX 3X5s
1. Insert the software loader card in the top slot of PFD1.
2. Power on PFD1 in configuration mode.
3. Press the NO softkey (number 11 softkey) to acknowledge the following prompt.
4. On PFD1, select the AIRCRAFT CONFIGURATION page.
5. Activate the cursor to select the "AIRCRAFT REGISTRATION" field and enter the
aircraft's tail number.
6. For non-US "N" number aircraft registrations, rotate the large FMS knob to select the
"ICAO ADDRESS" and enter the aircraft's 24 bit ICAO address. US "N" number aircraft
registrations are automatically decoded and entered in this field, do not change the
number.
7. If applicable, rotate the large FMS knob to select the "ICAO REGION" field and select
the ICAO region. Otherwise, leave at "NONE".
8. If applicable, rotate the large FMS knob to select the "DOMAIN IDENTIFIER" field and
enter the number. Otherwise, leave blank.
9. Rotate the large FMS knob to select the "VFR CODE" field and enter the desired code
that will become active when the VFR key on a PFD is pressed.
10. Press the SET GTS softkey (if present) and acknowledge the prompt by pressing the
ENT key.
11. Deactivate the cursor.
12. Rotate large FMS knob to select "GTX 3X5" configuration page group.
13. On the "Transponder Airframe Configuration" page, verify the GTX1 and GTX 2
boxes at the top of the page are green and the tail number, ICAO address, and VFR
code that were entered previously are correct.
Equipped with Single GTX 345R (#1) and Single GTX 33 (#2)
1. Insert the software loader card in the top slot of PFD1.
2. Power on PFD1 in configuration mode.
3. Press the NO softkey (number 11 softkey) to acknowledge the following prompt.
4. Select the AIRCRAFT CONFIGURATION page on PFD1.
5. Activate the cursor to select the "AIRCRAFT REGISTRATION" field and enter the
aircraft's tail number.
6. Rotate the large FMS knob to select the "ICAO ADDRESS" and enter the aircraft's 24
bit ICAO address.
7. If applicable, rotate the large FMS knob to select the "ICAO REGION" field and select
the ICAO region. Otherwise, leave at "NONE".
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Page 85
Revision 1