Figure 3-1, Set>Actv Diagram - Garmin G1000 Nxi System Maintenance Manual

Data can be manually copied from one column to the other (and consequently from PFD
memory to the LRU memory and vice-versa) by using the following two softkeys, when
available:
•
SET>ACTV (read 'Set to Active') softkey: Allows the installer to send the information in
the SET column (data stored in the master config module) to the ACTV column (data
used by LRU).
•
ACTV>SET (read 'Active to Set') softkey: Causes the LRUs current settings to be copied
to the master configuration module as SET items.
The ACTV>SET softkey must be used with caution!
configured unit is installed, this softkey causes the wrong configuration to
replace the correct aircraft configuration.
In the first example shown in Figure 3-1 the SET columns do not match the ACTIVE
columns. The inequality between SET and ACTIVE indicates a configuration mismatch.
By pressing the SET>ACTV softkey, this copies the SET column to the LRU unit's
configuration memory. The settings then become the ACTIVE settings for the LRU being
configured.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
CAUTION:
Figure 3-1, SET>ACTV Diagram
If an improperly
Page 46
Revision 1