FliteCharts Functional Check
FliteCharts is enabled by default and only turned off if the ChartView Only option file has been
loaded. Reference Section 3.8.11 (FliteCharts) or Section 3.9.2 (Dual Charts) for configuring
FliteCharts.
This test is required only if FliteCharts or Dual Charts is enabled.
1. If Dual Charts are installed, ensure FliteCharts are set as the preferred charts.
2. With the G1000 in Normal Mode, use the GCU FMS knob to select Aux – System
Status page, then select MFD1 DB softkey.
3. Use the small FMS knob to scroll to CHART.
4. Verify "FliteCharts" is displayed in blue text adjacent to "CHART".
5. Verify the FliteCharts database cycle number is displayed in blue text and the
FliteCharts database is current.
6. Deactivate the cursor and use the GCU large FMS knob to select the Map - Navigation
Map page then press the Charts softkey.
7. Verify the airport chart is displayed and the following softkeys are displayed (some
softkeys may be grayed out):
•
CHRT OPT
•
Show Map
•
INFO 1
•
DP
•
STAR
•
APR
•
WX
•
NOTAM
•
Go Back
8. Press the CHRT OPT softkey and verify the following softkeys are displayed (some
softkeys may be grayed out):
•
All
•
Header
•
Plan
•
Profile
•
Minimums
•
Fit WDTH
•
Full SCN
•
Back
9. If no other service is to be performed, continue to the return-to-service checks in Section
9.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 347
Revision 1