Garmin G1000 Nxi System Maintenance Manual page 88

7. If TAWS-A Voice No Callout option is desired, repeat steps 2-6 to load the "King Air -
TAWS-A Voice No Callout Installation Option" file.
11) Non Garmin Options Configuration Load
Follow this procedure to configure non-Garmin items if installed.
1. Rotate the large FMS knob until the GROUP field is highlighted, rotate the small FMS
knob to activate the drop down menu. Rotate the small FMS knob and select "11) Non
Garmin Items" and press the ENT softkey.
2. In the ITEM window, rotate the small FMS knob to highlight the first item that was
checked on the Configuration checklist in section 3.6 in the 11) Non-Garmin Options
checklist group and press the ENT key to Select it.
3. In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
4. Press the Load softkey.
5. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
6. Press the ENT key to acknowledge the "Upload Complete" box.
7. If multiple selections were made for this Section on the Configuration checklist, repeat
steps 2-6 to load each additional option.
Save Configuration
Press the UPDT CFG softkey at the bottom of the SYSTEM UPLOAD page.
Press the ENT key to select YES in the pop-up window to start the update.
When the config module update is done, press the ENT key to select OK in the pop-up
window to close it.
Open PFD 1 circuit breaker, remove the software loader card and continue to the next
Section.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Page 75
Revision 1