Garmin G1000 Nxi System Maintenance Manual page 115

Special Tools
The following tools may be needed to perform maintenance tasks on G1000 equipment and/or
installation:
•
Servo Gearbox Slip Clutch Adjustment Tool – Garmin P/N T10-00110-01
•
WX-PA portable analyzer kit, Part Number 78-8060-5791-1 (If Stormscope is installed)
•
Gauging Equipment Tool SPF-4 (A1M-BCH-GE)*
•
If the GRA 5500 radar altimeter is installed without RS-422 connections to GIA2, obtain
GRA 5500 Sensor and Main Software from the Garmin Dealer Resource Center at
www.garmin.com
A0451-00. Download the software part number and versions listed in the General
Arrangement Drawing for the GRA 5500. Instructions to download the GRA software
and using the GRA Retrofit Installation Tool are in Section 3.17.
* The gauging equipment tool is used for the static port inspection for RVSM
compliant aircraft only. This tool is available from Beechcraft. Any alternate
tool authorized in the King Air 300 Series Maintenance Manual for RVSM static
port measurements may be substituted for this tool. Refer to Chapter 34-10-
00 of the King Air 300 Series Maintenance Manual for more details.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
and load with the GRA Retrofit Installation Tool part number 006-
Page 102
Revision 1