Garmin G1000 Nxi System Maintenance Manual page 283

24. Press the CNFM CFG softkey.
25. Select ok when prompted to "Confirm configuration as expected configuration"
26. Power cycle the system. Verify there are no red-Xs or system alerts.
27. If red-Xs or system alerts are present, troubleshoot as necessary using Section 5 or re-
load the system using the legacy method in Section 7.3.2.
28. If there are no red-Xs or system alerts, continue to Section 7.3.3.
Legacy Replacement Procedure GIA1 or GIA2 (Alternate Method)
To load the GIA complete the following subsections in order as they apply to the aircraft.
01) Baseline (For GIA 1 or GIA 2 replacement)
1. Insert the software loader card in the top slot of PFD1.
2. Power on PFD2, MFD, and PFD1 in configuration mode.
3. Select NO when "Do you want to update system files" is displayed on the screen of
PFD1.
4. Select the "SYSTEM UPLOAD" page using the small FMS knob on PFD1.
5. Activate the cursor and rotate the small FMS knob to display the drop down menu.
Rotate the large FMS knob to highlight "01) Baseline" and press ENT key on PFD1.
6. Rotate the small FMS knob to display the drop down menu. Rotate the large FMS knob
to highlight King Air 200-300 Series Baseline Load Press ENT key on PFD1.
7. Press the CLR ALL softkey.
8. Use the large FMS knob to scroll to GIA 1 or GIA 2 whichever was replaced.
9. Highlight the software box and press the ENT key to check the box.
10. Highlight the Configuration box and press the ENT key to check the box.
11. Scroll to GIA 1 or GIA 2 Region Config, whichever was replaced.
12. Highlight the Configuration box and press the ENT key to check the box.
13. Scroll to NAV 1 or NAV 2, whichever was replaced.
14. Highlight the Software box and press the ENT key to check the box.
15. Scroll to COM 1 or COM 2, whichever was replaced.
16. Highlight the Software box and press ENT key to check the box.
17. Highlight the Configuration box and press the ENT key to check the box.
18. Scroll to GPS/WAAS 1 or GPS/WAAS 2, whichever was replaced.
19. Highlight the Software box and press the ENT key to check the box.
20. Scroll to GIA 1 or GIA 2 AUDIO, whichever was replaced.
21. Highlight the Software box and press the ENT key to check the box.
22. Scroll to AUDIO CONFIG.
23. Highlight the Configuration box and press the ENT key to check the box.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
Page 270
Revision 1