Replacing An Mx240 Fpc; Removing An Mx240 Fpc; Figure 133: Attaching A Cable To A Dpc - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide

Replacing an MX240 FPC

Removing an MX240 FPC

302

Figure 133: Attaching a Cable to a DPC

Removing an MX240 FPC on page 302
1.
Installing an MX240 FPC on page 305
2.
When you remove an FPC, the router continues to function, although the PIC interfaces
installed on the FPC being removed no longer function.
An FPC takes up two DPC slots on the MX240 router. One FPC can be installed horizontally
in the front of the router. The FPCs are hot-insertable and hot-removable. A fully
configured FPC can weigh up to 18 lb (8.2 kg). Be prepared to accept its full weight.
To remove an FPC (see Figure 134 on page
Have ready a replacement FPC or FPC blank panel and an antistatic mat for the FPC.
1.
Also have ready rubber safety caps for each PIC using an optical interface on the FPC
that you are removing.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
304):
Copyright © 2017, Juniper Networks, Inc.