Installing An Mx480 Routing Engine - Juniper MX480 Hardware Manual

Figure 97: Removing a Routing Engine

Installing an MX480 Routing Engine

To install a Routing Engine into an SCB
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Ensure that the ejector handles are not in the locked position. If necessary, flip the ejector handles
outward.
3. Place one hand underneath the Routing Engine to support it.
4. Carefully align the sides of the Routing Engine with the guides inside the opening on the SCB.
5. Slide the Routing Engine into the SCB until you feel resistance, and then press the Routing Engine's
faceplate until it engages the connectors.
(Figure 98 on page 304):
302