Installing An Mx240 Routing Engine - Juniper MX240 Hardware Manual

Figure 85: Removing a Routing Engine
SEE ALSO
MX240 Routing Engine Description | 69
Effect of Taking the MX240 Host Subsystem Offline
Replacing Connections to MX240 Routing Engine Interface Ports | 299
Preventing Electrostatic Discharge Damage to an MX240 Router | 467

Installing an MX240 Routing Engine

To install a Routing Engine into an SCB
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Ensure that the ejector handles are not in the locked position. If necessary, flip the ejector handles
outward.
3. Place one hand underneath the Routing Engine to support it.
4. Carefully align the sides of the Routing Engine with the guides inside the opening on the SCB.
5. Slide the Routing Engine into the SCB until you feel resistance, and then press the Routing Engine's
faceplate until it engages the connectors.
CAUTION:
(Figure 86 on page
Align the Routing Engine correctly to avoid damaging it.
291):
290