Installing The Routing Engine In A M7I Router; Figure 41: Removing The Routing Engine - Juniper M7i Hardware Manual

M7i Multiservice Edge Router Hardware Guide
See Also

Installing the Routing Engine in a M7i Router

142
Grasp the handle and slide the unit about halfway out of the chassis.
5.
CAUTION: Be careful to slide the Routing Engine straight out of the chassis.
Damage can result if it gets lodged because of uneven movement.
Place one hand under the Routing Engine to support it, slide it completely out of the
6.
chassis, and place it on the antistatic mat or in the electrostatic bag.

Figure 41: Removing the Routing Engine

Preventing Electrostatic Discharge Damage to an M7i Router on page 228
M7i Chassis Description on page 11
M7i Routing Engine Description on page 17
Installing the Routing Engine in a M7i Router on page 142
Maintaining the M7i Routing Engine on page 192
To install the Routing Engine (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
1.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
Place one hand under the Routing Engine to support it and grasp the handle on the
2.
faceplate with the other hand.
Align the rear of the Routing Engine with the guide rails inside the chassis and slide it
3.
in completely.
CAUTION: Be careful to align the Routing Engine correctly with the guide
rails and push it in evenly. Damage can result if it gets lodged in the rails
because of uneven movement.
Figure 42 on page 143):
Copyright © 2019, Juniper Networks, Inc.