Removing the T640 Standard or Quiet Rear Fan Tray
Copyright © 2013, Juniper Networks, Inc.
Figure 67: Removing an SCG
WARNING:
Use this procedure only for routers that are powered off.
The rear fan tray is mounted vertically on the right side of the rear of the chassis. Each
standard or quiet rear fan tray weighs about 10 lb (4.5 kg).
To remove the rear fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the top and bottom of the fan tray faceplate, using a
2.
Phillips (+) screwdriver, number 2.
Grasp the handles and pull the fan tray out of the chassis.
3.
Chapter 10: Installing the T640 Router Without a Mechanical Lift
Figure 68 on page
116):
115