Equipment Initialization
1.
Connect the equipment as shown in F'igure 2-8. Let the anaiyzer warm up
for one hour.
While the equipment is warming up, review the "Connector Care Quick
2.
Reference" information in the "Service Equipment and Anaiyzer Options"
chapter. Good connections and clean, undamaged connectors are critical for
accurate measurement results
Insert the veriiication kit disk into the analyzer disk drive.
3.
4.
5.
If you switch on the record function at this point, you CAMV~
Note
6. Position the paper in the printer so that printing starts at the top of the
Page.
If you have difKcuIty with the printer:
7.
System Vezifkation lkst Setup
.