Required Equipment and Accessories
The following equipment and accessories are required to verify the network
analyzer system (for information on compatible printers, refer to the "Printing,
Plotting, and Saving Measurement Results" chapter in the HP 87190/200/220
Network Analyzer User's Guide.)
Centronics Interface cable (1)
n
Calibration Kit
n
n
Supported System Configurations (HP 8719D/2OD Only)
Supported System Colons (HP 8722D Only)
I
I cabl e 6
system have been characterized for connector repeatability, magnitude and
phase stability with flexing, return loss, insertion loss, and aging rate. Since the
performance of test port cables is a very signihmt contributor to the system
performance, substituting specified cables with cables of lower performance
will increase the uncertainty of your measurement verification. Refer to the
3.5 mm
I
2.4 mm
I
I
3.5 mm
I
I
I
I
I
I