Agilent Technologies HP 8719D Service Manual page 471

DISK MESSAGE LENGTH ERROR,
DISK: not on, not connected, wrong
addrs, 10-44
DISK READ/WRITE ERROR, lo-45
error, lo-40
INITIALIZATION FAILED, lo-46
NO CALIBRATION CURRENTLY IN
PROGRESS, lo-46
NO IF FOUND: CHECK R INPUT
LEVEL, lo-47
NO SPACE FOR NEW CAL. CLEAR
REGISTERS, lo-47
NOT ALLOWED DURING POWER
METER CAL, lo-48
NOT ENOUGH SPACE ON DISK
FOR STORE, lo-46
OVERLOAD ON INPUT A, POWER
REDUCED, lo-48
OVERLOAD ON INPUT B, POWER
REDUCED, lo-48
OVERLOAD ON INPUT R, POWER
REDUCED, lo-49
PARALLEL PORT NOT AVAILABLE
FOR COPY, lo-49
PARALLEL PORT NOT AVAIIABLE
FOR GPIO, lo-49
PHASE LOCK CAL FAILED, lo-50
PHASE LOCK FAILURE, lo-47
PHASE LOCK LOST, lo-50
POSSIBLE FALSE LOCK, lo-50
POWER METER INVALID, lo-51
POWER METER NOT SETTLED,
POWER SUPPLY HOT!, lo-52
POWER SUPPLY SHUT DOWN!,
POWER UNLEVELED, lo-51
PRINTER: error, 19-52
PRINTER: not handshaking, 10-52
PRINTER: not on, not connected,
wrong addrs, lo-52
PWR MTR: NOT ON/CONNECTED
OR WRONG ADDR, lo-51
SAVE FAILED. INSUFFICIENT
MEMORY, lo-53
SELF TEST #n FAILED, lo-53
SOURCE POWER TURNED OFF,
RESET UNDER POWER MENU,
10-53
SWEEP MODE CHANGED TO CW
TIME SWEEP, lo-53
TEST ABORTED, lo-54
TROUBLE! CHECK SETUP AND
START OVER, lo-54
WRONG DISK FORMAT, INITIALIZE
DISK, lo-54
messages
error, 10-2
microwave connector care, l-4
mnemonic definitions, lo-38
mnemonics for service keys, 10-l
monitor ABUS node 9 for power,
4-19
motherboard check, 5-13
N
NO CALIBRATION CURRENTLY IN
PROGRESS, lo-46
NO FILE(S) FOUND ON DISK, lo-47
NO IF FOUND
CHECK R INPUT LEVEL, lo-47
NORMAL and AITER jumper/switch
position adjustment, 3-8
NO SPACE FOR NEW CAL. CLEAR
REGISTERS, lo-47
NOT ALLOWED DURING POWER
METER CAL, lo-48
NOT ENOUGH SPACE ON DISK FOR
STORE, lo-46