Checktheanalyzerinternal'ksts; Run The Operation Check - Agilent Technologies HP 8719D Service Manual

Check the Analyzer Internal 'lbts
This test is recommended to be done before the performauce tests, but is not
required.
These quick, automated internal checks may save time by indicating an
instrument fault before time is invested doing performance tests Internal tests
are described in the "Service Key Menus and Error Messages" chapter of this
manual.

Run the Operation Check

1. Connect a short to port 1.
2.
attenuator setting check has failed. Press
attenuator settings
If the message FAIL appears on the analyzer display, the analyzer failed the
n
If the message DONE appears on the analyzer display, the analyzer passed
n
the ilrst part of the check.
Connect the short to port 2.
3.
To run the second part of the operation check, press the following keys:
4.
attenuator setting check has failed. Press
attenuator settings
If the message FAIL appears on the analyzer display, the analyzer failed the
l
first part of the operation check.
System Vdficatii~ and
check the other
check the other