Agilent Technologies HP 8719D Service Manual page 275

System Verification Tests
These tests apply mainly to system-level, error-corrected verification and
troubleshooting. Tests 26 to 30 are associated with the system verification
procedure, documented in the "System Verification and Performance Tests"
chapter. Tests 31 to 42 facilitate examinin g the calibration coefficient arrays
(error terms) resulting from a measurement calibration; refer to the "Error
Terms" chapter for details.
26 Sys Ver Init. Recalls the initialization state for system verification
from an analyzer verification disk, in preparation for a measurement
calibration. It must be done before service internal tests 27,
28, 29 or 30 are performed.
Ver Dev
27 1. Recalls verification limits from disk for verification device
limit testing of the current measurement.
Ver Dev 2. Same as 28 above
28
Ver Dev 3. Same as 28
29
Ver Dev 4. Same as 28
30
31-42 Cal
array to display memory. A measurement calibration must be complete
and active. The definition of calibration arrays depends on the current
calibration type. After execution, the memory is automatically
displayed. Refer to the "Error Term" chapter for details.
1 O-1 6 Service Key Menus and Error Messages
for device #2.
above for device #3.
above for device #4.
Copies error term data from a measurement calibration