41. If the record function is off (printout is not required), the program will
each §-parameter measurement and you will need to press
after each measurement. (There are eight measurements:
magnitude and phase for each of the four S-parameters)
Although the verification limits for all four Z¶meters are
Note
calculated, only the uncertainties aswchted with the items
indicated in the following chart will be used for the system
verification. The other characteristics are less signScant for
verifylug system performance; therefore, they will not appear
on the printout. If a measurement fails, note which device and
S-parameter failed, and continue on with the remaining tests
Also note that both the measured data and the factory data are
displayed as DATA and
NETWORK ANALYZER
Verification Device Connections
.
The tests W-U begin.
respectively.