Agilent Technologies HP 8719D Service Manual page 300

BATTERY FAILED. STATE MEMORY CLEARED
Error Number The battery protection of the non-volatile CMOS memory has
183 failed. The CMOS memory has been cleared. Refer to the
"Assembly Replacement and Post-Repair Procedures" chapter
for battery replacement instructions. See the "Preset State and
Memory Allocation, n chapter
memory.
BATTERY LOW! STORE SAVE REGS TO DISK
Error Number The battery protection of the non-volatile CMOS memory is in
184 danger of failing. If this occurs, ah of the instrument state
registers stored in CMOS memory will be lost. Save these states
to a disk and refer to the "Assembly Replacement and
Post-Repair Procedures" chapter for battery replacement
instructions. See the U Preset State and Memory Allocation, n
chapter
BLOCK INPUT ERROR
Error Number The analyzer did not receive a complete data transmission. This
34
is usually caused by an interruption of the bus transaction.
Clear by pressing the ILocal) key or aborting the I/O process at
the controller.
BLOCK INPUT LENGTH ERROR
Error Number The length of the header received by the analyzer did not agree
3 5
with the size of the internal array block. Refer to the
instructions on using analyzer input commands.
User's cuide for more information about the CMOS
the
in HP 8719D/2OD/22D Network Analgzzr User's
the
in HP 8719D/2OD/22D Network
Service Key Menus and Error Messages
HP
for
1041