Measurement Calibration - Agilent Technologies HP 8719D Service Manual

Measurement Calibration

12. Connect the open that is supplied in the calibration kit to reference test
port 1.
REFERENCE TEST
Figure 2-9. erections
14. When the analyzer Mshes measuring the standard, connect the short that
is supplied in the calibration kit to reference test port 1.
16. When the analyzer Wishes measuring the standard, connect the 60 ohm
termination that is supplied in the calibration kit to reference test port 1.
Note
combination of lowband (or broadband) and sliding loads Use
the same loads used during normal calibrations
System V4ficntien and
NETWORK ANALYZER
( m )
PORT 1
for Measurement CUbration Stadards
( f ) CABLE 2
REFERENCE TEST
PORT 2